Wireless N+

Could be a dud. Sorry you had issues. Sounds like it worked great at first.


Yeah it was. Funny thing is a lot of reviews said the same thing great entail performance then it crapped out.

It may be an interference issue.

From an earlier post, I said...
"Also note that 802.11n uses 2 channels (40MHz in total, for those keeping score at home), so if you live in a congested area, you may run into noise problems with neighboring 802.11b/g/n devices."

802.11 has 12 channels in the US. Of those 12, only 3 are non-overlapping at 20MHz channel widths (b/g). So, theoretically, if you see 4 SSIDs, there is interference on at least one channel (and with devices coming from the factory set to channel 6, they all may be using the same channel!). N uses 40MHz channel widths, so you do the math on how much noise there may be on the 2.4GHz spectrum if all your neighbors are using N too.

You can change the channel on which your device operates. Do a site survey, ie look at all the SSIDs visible from your device, and note their signal strength and channel number. Set your device to use an empty channel, or a channel with the lowest signal if a device is already operating on that channel.


you may be right but is now back in the return pile at Best Buy. I am getting FIOS at the end of summer I will re-visited the issue after the install.

The wireless router market is a crapshoot...pick a router and hope for the best.

It may be an interference issue.

From an earlier post, I said...
"Also note that 802.11n uses 2 channels (40MHz in total, for those keeping score at home), so if you live in a congested area, you may run into noise problems with neighboring 802.11b/g/n devices."

802.11 has 12 channels in the US. Of those 12, only 3 are non-overlapping at 20MHz channel widths (b/g). So, theoretically, if you see 4 SSIDs, there is interference on at least one channel (and with devices coming from the factory set to channel 6, they all may be using the same channel!). N uses 40MHz channel widths, so you do the math on how much noise there may be on the 2.4GHz spectrum if all your neighbors are using N too.

You can change the channel on which your device operates. Do a site survey, ie look at all the SSIDs visible from your device, and note their signal strength and channel number. Set your device to use an empty channel, or a channel with the lowest signal if a device is already operating on that channel.
I had initially wrote about interference, but pulled back as I've gotten a bad router from Linksys before.

I recently switched security on my G router from WEP to WPA in order to get my work Win7 Laptop to connect (Never had any hacking issues with WEP, so I never changed it; and for some reason, Win7 did not like WEP), and it was dropping the signal on all computers, having to reboot my router every 12-18 hours. Changed the channel, and boom, no more issues or reboots.

The wireless router market is a crapshoot...pick a router and hope for the best.

Pretty much. They're all cheapo knockoffs from their commercial grade stuff.

I changed my channel out of the box for the various reasons above. Still running G and haven't had a problem with the router yet. I stream Netflix to a Roku over it with no problem...through two floors from the corner of a sub-terrain basement. I'm afraid to switch to N since my G has been so rock solid .